1969 WARNER & SWASEY 4A M-3550 Lot 48
Lathes, Turret Saddle Type
4 A Used Warner & Swasey Square Head Saddle Type Turret Lathe
| Model | 4A M-3550 |
| Swing | 28.25" |
| Center Distance | 144 in |
| Dimensions | 20' Long X 4" Wide X 84" High |
| Weight | 24,000 Lbs. |
Swing Over Bed Ways 28-1/4"
Swing Over Cross Slide Carriage 22"
Center Distance 144"
Spindle Hole 9-1/4"
Spindle Speeds 20 To 526 Rpm's
Chuck Size Front (Power Wrench) 24" 3-Jaw
Chuck Size (New Heavy Duty) 24" 4-Jaw Gator
Spindle Nose A-15
Feeds Cross .004 To .090 I.P.R.
Feeds Long. .005 To .167 I.P.R.
Main Motor With OffSet 75/37.5 Hp.
Flange Holders 4
Weight 24,000 Lbs.
Floor Space Right To Left 24'
Floor Space Front To Back 7'
Machine Height 80"
Slide Tool Holder 1
Power Wrench Yes
Tool Post 4 Way On Front Yes
Cross Sliding Rear Turret Yes
Full Chip Pan And Coolant Yes
Power Wrench Yes
Coolant Yes
Note: Machine has been reconditioned.
Note Reconditioning: Machine's front & rear aprons and rapid traverse box have been reconditioned. Rapid traverse drive box reconditioned, new bearings in main motor. New feed and rapid shafts. Headstock cleaned and flushed, new filters and oil. New lockdown pin and bushing in hex and square turret. New nut and screw in cross slide and hex turret. Gibs reworked and refitted. New 28"4-jaw Gator chuck with reconditioning. It is recommended that you re-bore the flange tool holders on the rear turret to ensure they are on center once the machine is level. Machine has been cleaned, painted, and cycled. Machine may be seen under power with proper notice.
