3 A Used Warner & Swasey Square Head Saddle Type Turret Lathe
Swing Over Bed Ways......................................23-1/2"
Swing Over Cross Slide Carriage..........................18"
Center Distance..........................................43"
Spindle Hole.............................................6-1/4"
Spindle Speeds...........................................24 To 851 Rpm's
Spindle Nose.............................................A-15
Chuck Size...............................................20" 3-Jaw Power Wrench
Feeds Cross..............................................0.0025 To 0.082 I.P.R.
Feeds Long...............................................0.005 To 0.167 I.P.R.
Main Motor...............................................60/30 Hp. 480 Volts
Flange Holders...........................................Short 5
Weight...................................................15,000 Lbs.
Floor Space..............................................180" L. X 84" W.
Machine Height...........................................64"
Coolant..................................................Yes
Tool Post 4 Way On Front.................................Yes
Rapid Traverse Front And Rear............................Yes
Cross Sliding Rear Turret................................Yes
Taper Attachments Front and Rear.........................Yes
Power Wrench.............................................Yes
Note:
Machine will be cleaned, painted and cycled.
Condition................................................Good
Note:
Machine Will Have Front & Rear Aprons And Rapid Traverse Box Reconditioned.
Rapid Traverse Drive Box Reconditioned.
New Bearings, In Main Motor.
New Feed And Rapid Shafts.
New Feed Keys and Bushing.
New Rapid Traverse Keys And Bushings.
New Lockdown Pin And Bushing In Hex And Square Turrets.
New Nut And Screw In Front Cross Slide.
New Nut And Screw In Rear Cross Slide.
Gibs Reworked And Refitted.
New Filter And Oil.
Headstock Cleaned And Flushed.
Power Wrench Chuck Taken A Part And Cleaned And New Pinion Installed.
Machine May Be Seen Under Power With Proper Notice.
It is recommended that you re-bore the flange tool holders on the rear turret
to ensure they are on center once the machine is level.
Price after reconditioning $72,500.00
Reconditioning will take 14 to 16 weeks after receipt of
Purchase Order And Parts Availability.
We use cookies to improve your experience. Privacy Policy.