54" Used Bullard Cut Master Vertical Turret Lathe
Have one to sell?
ConditionUsed
1 available
54" Used Bullard Cut Master Vertical Turret Lathe
Table Size 54"......................................4 Jaw
Swing Side Head Above Table.........................58"
Swing Side Head Below Table.........................62"
Height Under Rail...................................44"
Rail Travel Vertical................................36"
Table Speed.........................................4.4 To 160 Rpm's
Side Head Travel Horizontal.........................27"
Side Head Travel Vertical...........................44-1/4"
Turret Head Horizontal Travel.......................34-3/8"
Turret Head Vertical Travel.........................30-1/2"
Turret Head Position................................5
Turret Head Swivel Right & Left Of Center...........30 Degrees
Ram Swivel Right To Left Of Center..................30 Degrees
Ram Head Travel Up & Down...........................44-1/4"
Ram Head Travel In and Out..........................34-3/8"
Feeds...............................................0.0026 To .500 I.P. R.
Main Motor..........................................40 Hp. 220/440
Over-All Dimension Right To Left....................154"
Over-All Dimension Front To Back....................116"
Over-All Dimension Height...........................124"
Machine Weight......................................60,000 Lbs.
Pendant Control.....................................Yes
Rapid Traverse On All Heads.........................Yes
Note: Reconditioning:
Machine Has Been Cleaned, Painted And Cycled.
1. Turret Slide & Swivel in our facility. Dismantle unit as required. Clean all component parts.
2. Re-machine all bearing surfaces of the Turret Slide to remove localized wear.
3. Re-machine all bearing surfaces of the Turret Swivel to accept Turcite Way material.
4. Install Turcite to the Swivel and machine to correct height to compensate for material removed from Turret Slide.
5. Machine or grind oil grooves into swivel material for proper delivery of lubrication oil.
6. Block and hook frost all bearing surfaces of the turret slide for "pockets" for retention of lubrication oil.
7. Precision scrape and fit turret slide to swivel for proper bearing fit.
8. Manufacture new meehanite cast iron gibs for turret slide. Oil groove for proper delivery of lubrication oil. Precision scrape and fit allowing full range of adjustment to compensate for any future wear. These gibs will be the earless type.
9. Install triple lead down-feed screw and nuts. Install into nut body and realign to assure smooth and accurate operation.
10. Hang turret assembly in vertical position and reset turret locking mechanism for proper operation. Reset backlash eliminator to proper setting.
11. Cross-rail screws and nut will be replaced in ram and turret saddles.
12. Turret and ram vertical screws and nuts replaced.
13. All feed and rapid shafts seals will be replaced. Hand wheel seals will be replaced. Gear boxes will be cleaned and checked.
14. Shifting solenoid and block reconditioned and brought to factory specs.
15. Hydraulics and main motor will be reconditioned.
Machine should be ready to ship in about 16 to 20 weeks after receipt of PO and down payment.
Price after reconditioning $164,500.00
We use cookies to improve your experience. Privacy Policy.