Used 1955 BULLARD 36" CUT MASTER | Boring Mills, Vertical Turret Lathe

Chuck Size......................................36" 3-Jaw Scroll With Top Jaws.
Swing Side Head Above Table.....................36"
Height Under Rail...............................30"
Swing Side Head Below Table.....................38"
Table Speed.....................................4.9 TO 240 Rpm's
Feeds...........................................004 To .500 I.P.R.
Feeds...........................................003 To .333 I.P.R.
Turret Head Travel Left To Right................19.5"
Turret Head Swivel..............................30 Degrees
Turret Ram Head Turret Travel Up & Down.........34"
Turret Head Position............................5
Side Head Travel In & Out.......................19"
Side Head Travel Up & Down......................34"
Main Motor......................................40 Hp.
Floor Space.....................................R-L 120" X F-B 9'6"
Height..........................................115"
Weight..........................................36,000 Lbs.
Power Elevation Of Rail.........................Yes
Rapid Traverse To Both Head.....................Yes
Built In 4 Way Tool Post On Side Head...........Yes
Pendant Control.................................Yes

Note: Reconditioning:
Machine Will Be Cleaned, Painted And Cycled.
1. Turret Slide & Swivel in our facility. Dismantle unit as required. Clean all
component parts.
2. Remachine all bearing surfaces of the Turret Slide to remove localized wear.
3. Remachine all bearing surfaces of the Turret Swivel to accept Turcite Way
material.
4. Install Turcite to the Swivel and machine to correct height to compensate for
material removed from Turret Slide.
5. Machine or grind oil grooves into swivel material for proper delivery of
lubrication oil.
6. Block and hook frost all bearing surfaces of the turret slide for "pockets" for
retention of lubrication oil.
7. Precision scrape and fit turret slide to swivel for proper bearing fit.
8. Manufacture new meehanite cast iron gibs for turret slide. Oil groove for proper
delivery of lubrication oil. Precision scrape and fit allowing full range of
adjustment to compensate for any future wear. These gibs will be the earless type.
9. Install triple lead downfeed screw and nuts. Install into nut body and realign
to assure smooth and accurate operation.
10. Hang turret assembly in vertical position and reset turret locking mechanism
for proper operation. Reset backlash eliminator to proper setting.
11. Cross-feed screws and nuts will be replaced.
12. Turret vertical screws and nuts replaced.
13. Main Shifting Solenoid Block Reconditioned / Rebuilt.
14. Hydraulics And Main Motor Will Be Reconditioned. New Belts New Oil And Filter.
15. All feed and rapid shafts seals will be replaced. Hand wheel seals will be
replaced, gear boxes will be cleaned and checked.
Machine should be ready to ship in about 24 to 30 weeks after receipt of PO.
Price will be $84,500.00 after reconditioning.

Optional:
Chuck Size 36" 4-Jaw Scroll With Independant Jaws.$20,500.00