One Used 5' X 13" Gidding & Lewis Radial Arm Drill

SPECIFICATIONS:
ARM LENGTH:..................................5′
COLUMN DIAMETER:.............................13″
SPINDLE SPEEDS:..............................(32) 15-1200 RPM
MORSE TAPER IN SPINDLE:......................# 5
DIAMETER OF SPINDLE AT POINT OF DRIVE:.......3 1/4”
FEED RANGE:..................................(9) .006 – .125 IPR
FEED TAP LEADS:..............................8 & 11 1/2 TPI
MINIMUM DISTANCE FACE OF COLUMN TO SPINDLE:..15″
HORIZONTAL TRAVERSE OF HEAD ON ARM:..........48″
DISTANCE SPINDLE TO BASE: MINIMUM:...........27″
DISTANCE SPINDLE TO BASE: MAXIMUM:...........87″
TRAVEL OF SPINDLE IN HEAD:...................20″
TRAVERSE OF ARM ON COLUMN:...................55″
HEIGHT OF BASE:..............................12"
MAIN DRIVE MOTOR:............................15 HP
ELECTRICS:...................................230/ 460 V/ 3 PH/ 60 HZ
FLOOR SPACE:.................................R-L 120″ x F-B 60″
Machine Height:..............................120"
WEIGHT:......................................24,000 LBS
Plain Bos Table..............................24" X 30" X 24" H
POWER CLAMPING TO COLUMN AND HEAD
POWER RAPID HEAD TRAVERSE
HYDRAULIC PRE-SELECT OF FEED AND SPEEDS
HYDRAULIC POWER CLAMPING OF HEAD AND ARM
HYDRAULIC POWER ELEVATION OF ARM ON COLUMN
COOLANT SYSTEM
AUTOMATIC LUBRICATION TO HEAD
CLUTCH ON SPINDLE FEED