42" Used Bullard (Cut Master) Vertical Turret Lathe Model 42 Floor Shift
Boring Mills, Vertical Turret Lathe
42" Used Bullard (Cut Master) Vertical Turret Lathe Model 42 Floor Shift
| Table Dia | 42" |
| Swing | 46" |
| Work Ht-U/R | 37" |
| Power | 30 hp |
| RPM | 200 RPM |
| Dimensions | R-L 105" X F-B 118" X 10'2" High |
| Weight | 42,500 Lbs. |
Table Size..............................................42" 4-Jaw
Swing Side Head Above Table.............................45"
Swing Side Head Below Table.............................54"
Cross Rail Travel.......................................25"
Height Under Rail.......................................37"
Table Speed.............................................4.1 To 200 Rpm's
Feeds...................................................026 To 500 IPR
Turret Head Travel Left To Right........................30-3/8"
Turret Head Swivel......................................30 Degrees
Turret Ram Head Turret Travel Up & Down.................37"
Max. Distance Table To Turret Face......................48-1/4"
Turret Head Position....................................5
Left Head Ram Travel Right To Left......................26-3/8"
Left Hand Ram Travel Up & Down..........................30.5"
Left Hand Ram Swivel....................................30 Degrees R To L
Left Hand Ram Tool Post Hole............................3-3/8"
Side Head Travel In & Out...............................21"
Side Head Travel Up & Down..............................37"
Main Motor..............................................30 Hp.
Machine Floor Space.....................................R-L 105" X F-B 118"
Machine Height..........................................10'2"
Machine Weight..........................................42,500 Lbs.
Power Elevation Of Rail.................................Yes
Rapid Traverse To Both Head.............................Yes
Built In 4 Way Tool Post On Side Head...................Yes
Turret Head.............................................Yes
Floor Shift.............................................Yes
Condition: Goodloor Shift Yes
Note: Reconditioning:
Machine Has Been Cleaned, Painted And Cycled.
1. Turret Slide & Swivel in our facility. Dismantle unit as required. Clean all component parts.
2. Remachine all bearing surfaces of the Turret Slide to remove localized wear.
3. Remachine all bearing surfaces of the Turret Swivel to accept Turcite Way material.
4. Install Turcite to the Swivel and machine to correct height to compensate for material removed from Turret Slide.
5. Machine or grind oil grooves into swivel material for proper delivery of lubrication oil.
6. Block and hook frost all bearing surfaces of the turret slide for "pockets" for retention of lubrication oil.
7. Precision scrape and fit turret slide to swivel for proper bearing fit.
8. Manufacture new meehanite cast iron gibs for turret slide. Oil groove for proper delivery of lubrication oil. Precision scrape and fit allowing full range of adjustment to compensate for any future wear. These gibs will be the earless type.
9. Install triple lead downfeed screw and nuts. Install into nut body and realign to assure smooth and accurate operation.
10. Hang turret assembly in vertical position and reset turret locking mechanism for proper operation. Reset backlash eliminator to proper setting.
11. Cross-rail screws and nut will be replaced in ram and turret saddles.
12. Turret and ram vertical screws and nuts replaced.
13. All feed and rapid shafts seals will be replaced. Hand wheel seals will be replaced, gear boxes will be cleaned and checked. Hydraulics and main motor will been reconditioned.
Machine should be ready to ship in about 10 to 12 weeks after receipt of PO.
