4 A Used Warner & Swasey Square Head Saddle Type Turret Lathe
Lathes, Turret Saddle Type4 A Used Warner & Swasey Square Head Saddle Type Turret Lathe
Model | M-3550 |
Swing | 28.25" |
Center Distance | 62 in |
Dimensions | 20' Long. X 84' Wide X 84 High |
Weight | 24,000 Lbs. |
Swing Over Bed Ways 28-1/4"
Swing Over Cross Slide Carriage 22"
Center Distance 62"
Spindle Hole 9-1/4"
Spindle Nose A-15
Chuck Size 24" 4- Jaw
Spindle Speeds 20 To 526 Rpm's
Front & Rear Feeds Long. .005 To .167 I.P.R.
Front & Rear Feeds Cross .004 To .090 I.P.R.
Main Motor 75/37.5 Hp. 440 Volts
Floor Space Front To Back 7'
Floor Space Right To Left 20'
Machine Height 84"
Weight 22,000 Lbs.
Flange Holders 4
Full Chip Pan And Coolant Yes
Taper Attachment Front Apron Yes
Cross Sliding Rear Turret Yes
Rapid Traverse Front And Rear Yes
Tool Post 4 Way On Front Yes
Note: Machine is in good working order.
Machine has been cleaned, painted and cycled.
Note Reconditioning: Machine will have front & rear aprons and rapid traverse box reconditioned. Rapid traverse drive box reconditioned, new bearings in main motor. New feed and rapid shafts. Headstock cleaned and flushed, new filters and oil. New lockdown pin and bushing in hex and square turret. New nut and screw in cross slide and hex turret. Gibs reworked and refitted. Installed power wrench chuck and wrench. It is recommended that you re-bore the flange tool holders on the rear turret to ensure they are on center once the machine is level. Machine will be cleaned, painted, and cycled. Machine may be seen under power with proper notice.
Price: $149,500.00 for the above work completed.
If you would like the machine reconditioned, the above work
will be started once the PO received.
Estimated time frame six to eight weeks
Price has is Cleaned, Painted and Cylced. $99,500.00