4 A Used Warner & Swasey Square Head Saddle Type Turret Lathe
Lathes, Turret Saddle Type4 A Used Warner & Swasey Square Head Saddle Type Turret Lathe
Model | 4A M-3550 |
Swing | 28.25" |
Center Distance | 62 in |
Dimensions | 20' Long. X 84" Wide X 84" High |
Weight | 24,500 Lbs. |
Swing Over Bed Ways 28-1/4"
Swing Over Cross Slide Carriage 22"
Center Distance 62"
Spindle Hole 9-1/4"
Spindle Speeds 20 To 526 Rpm's
Spindle Nose A-15
Chuck Size 24" 3-Jaw Power Wrench
Chuck Size (New Heavy Duty) 24" 4- Jaw New Gator
Feeds Cross 4 To .090 I.P.R.
Feeds Long. .005 To .167 I.P.R.
Main Motor 75 / 37.5 Hp. 440 Volts
Flange Holders Short 4
Flange Holders Long 1
Floor Space Front To Back 7'
Floor Space Right To Left 20'
Machine Height 80"
Weight 24,000 Lbs.
Power Wrench & Chuck Yes
Taper Attachment Front Apron. Yes
Tool Post 4 Way On Front Yes
Rapid Traverse Front And Rear Yes
Cross Sliding Rear Turret Yes
Full Chip Pan And Coolant Yes
Taper Attachment Front Apron Yes
Note: Machine has been reconditioned.
Note Reconditioning: Machine's front & rear aprons and rapid traverse box have been reconditioned. Rapid traverse drive box reconditioned, new bearings in main motor. New feed and rapid shafts. Headstock cleaned and flushed, new filters and oil. New lockdown pin and bushing in hex and square turret. New nut and screw in cross slide and hex turret. Gibs reworked and refitted. New 24"4-jaw Gator chuck with reconditioning. It is recommended that you re-bore the flange tool holders on the rear turret to ensure they are on center once the machine is level. Machine has been cleaned, painted, and cycled. Machine may be seen under power with proper notice.